Developing DTL Transformations
This chapter describes the syntax rules for referring to properties and for creating expressions within various DTL actions. It contains the following sections:
In most actions within a transformation, it is necessary to refer to properties of the source or target messages. The rules for referring to a property are different depending on the kind of messages you are working with.
When you assign a value to a target property, you often specify a literal value. Literal values are also sometimes suitable in other places, such as the value in a trace
A literal value is either of the following:
Because DTL transformations are saved as XML documents, you must use XML entities in the place of XML reserved characters:
"Joe's "Good Time" Bar & Grill"
This restriction does not apply inside code
actions, because InterSystems IRIS™ automatically wraps a CData block around the text that you enter into the editor. (In the XML standard, a CData block encloses text that should not be parsed as XML. Thus you can include reserved characters in that block.)
In most of the virtual document formats, specific characters are used as separators between segments, between fields, between subfields, and so on. If you need to include any of these characters as literal text when you are setting a value in the message, you must instead use the applicable escape sequence, if any, for that document format.
These characters are documented in the applicable books. For details, see:
In a data transformation, the separator characters and escape sequences can be different for the source and target messages. InterSystems IRIS automatically adjusts values as needed, after performing the transformation. This means that you should consider only the separator characters and escape sequences that apply to the source
If the character (for example, &
) is a separator and you want to include it as a literal character, use the escape sequence that applies to the virtual document format.
You can include decimal or hexadecimal representations of characters within literal strings.
The string &#n;
represents a Unicode character when n
is a decimal Unicode character number. One example is é
for the Latin e character with acute accent mark (é).
Alternatively, the string &#xh;
represents a Unicode character when h
is a hexadecimal Unicode character number. One example is ¿ for the inverted question mark (¿).
When you assign a value to a target property, you can specify an expression, in the language that you selected for the data transformation. You also use expressions in other places, such as the condition for an if
action, the value in a trace
action, statements in a code
action, and so on.
The following are all valid expressions:
References to the aux
variable passed by the rule. If the data transformation is called from a rule, it supplies the following information in the aux
aux.BusinessRuleNameName of the rule.
aux.RuleReasonReason that the rule was fired. It is the same name as used in the logging. An example value is 'rule#1:when#1'. If the RuleReason is longer than 2000 characters, it is truncated to 2000 characters.
aux.RuleUserDataValue that was assigned in the rule to the property 'RuleUserData'.
If the data transformation is called directly from code and not from a rule, the code can pass the auxiliary data in the third parameter. If your data transformation may be called from code that does not set the third parameter, your DTL code should check that the aux
variable is an object in an if
action using the $ISOBJECT
Content Date/Time: 2019-07-19 06:48:24