Install the Healthcare Action Engine on InterSystems IRIS for Health
To set up an functional InterSystems® Healthcare Action Engine namespace on an instance of InterSystems IRIS® for Health, perform the following steps:
-
Install an InterSystems IRIS for Health instance and acquire the Healthcare Action Engine module installation package, as described in Deployment Prep.
-
Extract the HAE module installation package in a temporary directory on your system.
-
Start a Terminal session on the instance and switch to a namespace where you can load and compile the installer class.
-
Load and compile the installer class by executing the following command:
do $system.OBJ.Load("<tempDir>/Installer.MountInstallHAE.cls","ck")
-
Run the installer routine by executing the following command:
set status=##class(Installer.MountInstallHAE).InstallPackage("<tempDir>",1)
The installer routine loads all the necessary code to run HAE and sets up a functional Healthcare Action Engine namespace. By default, the name of this namespace is HAE1.
-
When the installer has finished, start the Healthcare Action Engine production by performing the following steps:
-
Open the Management Portal and switch to your Healthcare Action Engine namespace.
-
From the Management Portal Home page, select Interoperability > Configure > Production.
-
Select Start to start the Healthcare Action Engine production. Select OK to confirm, and then OK again when the production has started.
-
To finish configuring the Healthcare Action Engine, perform the steps described in Post-Deployment Tasks.